Epson TM-U675 Service Manual page 57

Confidential
25. Pass the flexible plastic cable (FPC) for the print head unit (Eb) through the slit in the
carriage assembly. When you do this, the FPC should be below the two hooks on the
carriage assembly. Install the print head unit (Eb) onto the carriage assembly. Connect the
FPC to the intermediate circuit board assembly connector.
26. Attach the nose guide on the print head unit (Eb) while aligning the three nibs. Secure the
nose guide with one screw.
27. Attach the head seal to the print head unit (Eb).
28. Lubricate the carriage motor gear and the top of the E-ring fastening the ribbon drive plate
assembly.
Slit
FPC
Print head unit (Eb)
Rev.D
Hooks
795
Head seal
G-36
689
FPC
688
Carriage frame sub assembly
TM-U675/U675P (with autocutter) Service Manual
623
Nose guide
689
Print head unit (Eb)
FPC
Figure 2-22
709 Carriage assembly
708
Intermediate circuit board assembly
Figure 2-23
608
Screw (C.P.P-tite, 3X12)
G-36
Assembly and Disassembly 2-23