Epson TM-U675 Service Manual page 53

Confidential
8. Insert the carriage drive transmission gear into the shaft shown in the figure below.
9. Insert the ribbon reduction gear into the shaft shown in the figure below.
10. Insert the ribbon intermediate gear into the shaft shown in the figure below. The smaller
diameter ribbon intermediate gear should be on the lower side.
11. Attach the ribbon drive plate assembly above the ribbon reduction gear and the ribbon
intermediate gear. Set the gear side of the ribbon drive plate assembly downward.
12. Attach the gear train cover to the carriage drive transmission gear.
13. Fasten the belt drive cap, carriage drive transmission gear, and ribbon drive plate assembly
with three E-rings.
Ribbon drive plate assembly
Carriage frame sub assembly
Rev.D
E-ring (2)
720
E-ring (2)
706
682
Ribbon reduction gear
TM-U675/U675P (with autocutter) Service Manual
720
634 Carriage drive transmission gear
683 Ribbon intermediate gear
720 E-ring (2)
Figure 2-18
768
Gear train cover
Assembly and Disassembly 2-19