Confidential
52. Attach the clamp to the front reinforcement frame.
53. Connect the control panel unit cable to the control panel circuit board assembly.
54. Attach the front case. Align with the hole in the front case and attach. When doing so, the
flat cable for the control panel unit should be on top of the cable wire for the control panel
cable.
CAUTION:
If the flat cable for the control panel unit is not on top of the cable wire for the
control panel cable, there is the possibility that the flat cable could be too short.
55. Fasten the front case using two screws.
Flat cable
for control panel unit
Cable wire
for control panel cable
Rev.D
104 Screw (C.C., 4X20)
110
Clamp
TM-U675/U675P (with autocutter) Service Manual
130 Front case
103 Screw (C.P.T-B, 3X10)
Figure 2-126
Assembly and Disassembly 2-125