Amount To Be Dispensed; Commissioning The Dispensing Pumps; Dispenser Calibration - Miele PW 413 Operating And Installation Instructions

Optional modules:
Avoiding block-
ages and corro-
sion in the dis-
pensing system.
To go directly to
"dispenser calib-
ration" when the
machine is
switched off:
62

Amount to be dispensed

Please follow the detergent manufacturer's instructions.
It is particularly important to observe manufacturer's instructions
when using a combination of cleaning agents and special applica-
tion products. Products must only be used for applications ap-
proved by the manufacturer to avoid any material damage or the
occurrence of strong chemical reactions. Confirmation must be
sought from the detergent manufacturer that using the agent in the
washing machine will not cause damage.
Correct dosage also depends on the viscosity of the liquid agent. It
should therefore be allowed to settle to room temperature before be-
ing used.
Cleaning and maintenance of the dispensing system
Rinse out the siphons with water.

Put the siphons in a container of warm water (40-50 °C).

Use dispenser calibration to activate each pump until the dispens-

ing system is rinsed through.
Check the connection points, hoses, dispensing sockets and wash-

ers for leaks.
Rinse the dispensing system through with hot water every 2 weeks,
or before shutting the dispenser pumps down for any length of time,
to avoid the system getting clogged up and corroded.

Commissioning the dispensing pumps

Before the liquid dispensing pumps can be used the liquid agent
must be drawn into the system and the amount to be dispensed set.

Dispenser calibration

Dispensing calibration is used to measure the throughput of individual
dispensing pumps.
Press and hold multifunction button 2 and switch the machine on

with Power on .
Dispenser calibration
Dispenser pump 1
Dispenser pump 2
Options:
– Dispenser pump 1 to 13
Select a dispenser pump.

Main menu


