5.
Push the green release latch on the right rear side of the drive toward the center of the drive (1), and
then slide the drive forward and out of the bay (2).
Installing a 9.5 mm slim optical drive
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
If you are installing a slim optical drive in a bay covered by a bezel blank, remove the front bezel and
then remove the bezel blank. See
4.
Align the small pin on the release latch with the small hole on the side of the drive and press the latch
firmly onto the drive.
(Preparation for disassembly on page
(Access panel on page
20)
Removing bezel blanks on page 23
19)
for more information.
Drives
43