Speaker - HP EliteDesk 800 G3 TWR Maintenance And Service Manual

Speaker

The speaker is attached to the front of the chassis. Remove it from the inside of the chassis.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the drive cage
4. Disconnect the speaker cable from the system board connector labeled SPKR (1).
5. Remove the Torx T15 screw (2) that secures the speaker to the chassis.
6. Slide the speaker to the right, and the remove the speaker from the chassis (3).
To replace the speaker, reverse the removal procedures.
60 Chapter 4 Removal and replacement procedures – Microtower (MT) chassis
(Preparation for disassembly on page
(Access panel on page
(Drive cage on page 28).
20).
19).