Power Supply - HP EliteDesk 800 G3 TWR Maintenance And Service Manual

Power supply

For a list of available power supplies, see
The power supply is secured to the rear of the chassis with three screws. Three cables connect the power
supply to the system board.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the drive cage
4. Remove the three Torx T15 screws that connect the power supply to the rear of the chassis.
5. From the inside of the chassis, remove the power supply cables from the clips built into the bottom of
the chassis.
6. Disconnect the power supply cables from the following system board connector:
● PWRCMD
64 Chapter 4 Removal and replacement procedures – Microtower (MT) chassis
Computer major components on page
(Preparation for disassembly on page
(Access panel on page
(Drive cage on page 28).
20).
5.
19).