Installing a 5.25-inch drive
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
blank, remove the bezel blank. See
4.
If you are installing an optical drive, install four M3 metric mounting screws (not provided) in the lower
holes on each side of the drive.
NOTE:
to the new one.
IMPORTANT:
components of the drive.
(Access panel on page
(Front bezel on page
When replacing an optical drive, transfer the four M3 metric mounting screws from the old drive
Use only 5 mm long screws as mounting screws. Longer screws can damage the internal
(Preparation for disassembly on page
20)
21). If you are installing a drive in a bay covered by a bezel
Removing bezel blanks on page 23
19)
for more information.
Drives
39