7/ I/O-Area Connectors; Dp Connectors Dp1, Dp2 (J14); Table 4: Pin Assignment Dp Connector Dp1, Dp2 (J14); Figure 6: Dp Connectors Dp1 (Top) And Dp2 (Bottom) - Kontron mITX-SKL-H User Manual

7/ I/O-Area Connectors

The following connectors are available on the connector panel of the mITX-SKL-H. For information regarding the
connector's position on the panel, see Chapter 5.2 Connector Panel Side.

7.1. DP Connectors DP1, DP2 (J14)

The mITX-SKL-H display port (DP) connectors are based on standard DP type Foxconn 3VD11203-DPA1-4H or similar.

Figure 6: DP Connectors DP1 (Top) and DP2 (Bottom)

Top
19
Bottom
39
40

Table 4: Pin Assignment DP Connector DP1, DP2 (J14)

Pin Signal Description
1/21
Lane 0
(+)
2/22
GND
3/23
Lane 0 (-)
4/24
Lane 1 (+)
5/25
GND
6/26
Lane 1 (-)
7/26
Lane 2 (+)
8/28
GND
9/29
Lane 2 (-)
10/30
Lane 3 (+)
11/31
GND
12/32
Lane 3 (-)
13/33
Config. 1 Aux or DDC
selection
14/34
Config. 2 (Not used)
15/35
Aux+ Aux Channel (+)
or DDC Clk
16
37 35
38 36 34
Type
LVDS
PWR
LVDS
LVDS
PWR
LVDS
LVDS
PWR
LVDS
LVDS
PWR
LVDS
I
O
www.kontron.com
13 9
10 8
33 31 29
32 30 28
Note
Internally pull down (1 MΩ).
Aux channel on pin-15/17 or pin-35/37 selected as default
(if NC).
DDC channel pin-15/17 or pin-35/37, if HDMI adapter used
(3.3 V).
Internally connected to GND
AUX (+) channel used by DP
DDC Clk used by HDMI
mITX-SKL-H – User Guide, Rev.1.1
7 5 3 1
6 4 2
27 25 23 21
26 24 22
// 31