Nilfisk-Advance CS7000 Service Manual page 405

Service Manual – CS7000
6. Remove the two
3/8"-16 x .75" Screws
holding the
Actuator Bracket Weldment
to the
Hopper Lift Weldment
7. Extend the side brooms in the Service
Mode to extend the side broom
actuator. This will give you some
additional clearance for better access
to the hair cotter pin holding the
to the side broom lift
Broom Actuator
weldment.
8. Use a long needle-nose pliers to
remove the
Hair Cotter Pin
the
Side Broom Actuator
on the side broom lift weldment and
remove it from the machine.
9. Reinstall the
Side Broom Actuator
following the above steps in reverse
order.
Note: Be careful not to rotate
the
Drive Nut Cylinder
the
Side Broom Actuator
when it's disconnected
from the machine. This
can change the extended
and retracted positions of
the
Side Broom Actuator
and the subsequent
extended and retracted
positions of the side
brooms.
.
Side
, then slide
off of the pin
Hair
by
Cotter
Pin
on
,
Sweep System, Side Broom
3/8"-16 x .75"
Screw (2)
Weldment
Hopper Lift
Weldment
Side Broom
Actuator
Actuator
Bracket
Side Broom
Actuator
Drive Nut
Cylinder
Adjustment
Cover
405