Nilfisk-Advance CS7000 Fuel Cell EcoFlex Installation Instructions
  1. Manuals
  2. Brands
  3. Nilfisk-Advance Manuals
  4. Floor Machine
  5. CS7000 Fuel Cell EcoFlex
  6. Installation instructions
Nilfisk-Advance CS7000 Fuel Cell EcoFlex Installation Instructions

Nilfisk-Advance CS7000 Fuel Cell EcoFlex Installation Instructions

Fuel cell module user interface panel installation
Hide thumbs Also See for CS7000 Fuel Cell EcoFlex:
1
2
3

Advertisement

Table of Contents

FUEL CELL MODULE USER INTERFACE PANEL INSTALLATION
This interface panel is supplied/acquired thru Plug Power
WARNING!
DISCONNECT BATTERIES BEFORE SERVICING.

UN-INSTALL STEERING WHEEL ASSEMBLY

1
Open the hood and operator side panel for access to steering wheel assembly.
2
See fi gure 1. Disconnect the Steering Wheel Rotation Sensor Connector (A) from the Wiring Harness (B).
3
Remove (2) Bolts (C) holding the Back Plate (J). This requires a 9/16" standard socket. NOTE: Impact sockets or other
thick-wall sockets may not work due to P Clamp (K).
FIGURE 1
4
See fi gure 2. Remove the (4) Screws (D) that mount the Steering Wheel Assembly (E) using a #3 Phillips screwdriver.
NOTE: It may be helpful to use the steering wheel Tilt Lever (G) to gain access to all the screws.
5
Remove Steering Wheel Assembly (E). NOTE: The steering assembly is very heavy, use caution when removing.
FIGURE 2
© 2012 Nilfi sk-Advance, Inc.
CS7000 Fuel Cell EcoFlex™
INSTALLATION INSTRUCTIONS
J
C
B
D
G
, typically at the same time as the fuel cell module.
®
K
(page 1 of 3)
A
E
D
8/12 Form No. 56090146 REV A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CS7000 Fuel Cell EcoFlex and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Nilfisk-Advance CS7000 Fuel Cell EcoFlex

Summary of Contents for Nilfisk-Advance CS7000 Fuel Cell EcoFlex

  • Page 1 FUEL CELL MODULE USER INTERFACE PANEL INSTALLATION CS7000 Fuel Cell EcoFlex™ INSTALLATION INSTRUCTIONS This interface panel is supplied/acquired thru Plug Power , typically at the same time as the fuel cell module. ® WARNING! DISCONNECT BATTERIES BEFORE SERVICING. UN-INSTALL STEERING WHEEL ASSEMBLY Open the hood and operator side panel for access to steering wheel assembly.
  • Page 2 INSTALL FUEL CELL MODULE CONTROL See fi gure 3. Place the Fuel Cell Module Control cable (F) through the opening as shown. The cable will lay in the depression in the center bottom of the opening. FIGURE 3 RE-INSTALL STEERING WHEEL ASSEMBLY See fi...
  • Page 3 RE-INSTALL STEERING WHEEL ASSEMBLY (CONTINUED) See fi gure 5. Install the Back Plate (J) and route the Fuel Cell Module Control cable (F) thru either one of the notched openings as shown. The Steering Wheel Rotation Sensor Connector (A) exits through the large opening. See fi...

Table of Contents