Nilfisk-Advance CS7000 Service Manual page 311

Service Manual – CS7000
11. Reinstall the
Scrub Deck
Service Note: When you reinstall the
• Make sure you reconnect the
follows:
– Left scrub motor - White/Orange wire
– Center scrub motor - Gray/Black wire
– Right scrub motor - Blue/Yellow wire
• Make sure the two
and washers are installed correctly before installing the two
Bushings
• You may find it easier to use a tapered punch or other suitable tool to align the
and
Bearings
M12-1.75x 35mm Screws
by following the above steps in reverse order.
Scrub Deck
Scrub Motors
are installed in the machine frame through holes, and that the
Flange Bearings
with the through holes in the frame before you install the
Deck Lift Arm Assembly
.
:
to the correct
Electrical Connectors
Scrub System
in the wire harness as
.
M12-1.75x 35mm Screws
,
Bushings Flange
311