Nilfisk-Advance CS7000 Service Manual page 392

Service Manual – CS7000
7. Remove the
Hair Cotter Pin
and
.50" x 1.75" Clevis Pin
top of the
Broom Lift Actuator
.
Spring Arm
8. Disconnect the
Broom Lift Actuator
electrical connector and remove the
from the machine.
Broom Lift Actuator
9. Reinstall the
Broom Lift Actuator
following the above steps in reverse
order.
10. Check the main broom height and
main broom sweep pattern and adjust
as necessary. (Refer to the
the Main Broom Height
, washers
holding the
to the
by
To Adjust
section.)
Spring Arm
.50" x 1.75"
Clevis Pin
Sweep System, Main
Hair Cotter
Pin
392