Direct Functions; Start Adjustment - Panasonic AJ-D400P Service Manual

E.V.R. Direct Functions
1. COMMAND INPUT FUNCTION
[ EVR FUNCTION ]
COMMAND
DATA
ADDRESS
[[
[ MACRO FUNCTION ]
1. CAMERA RESET No. 1
2. CAMERA RESET No. 2
3. VF OUT
4. MONITOR OUT LEVEL
<<Page Up: INC Page Down: DEC >>
[↑] : Move To Up
[→] : Data Increment [←] : Data Decrement
[ESC] : Quit
1. Select <6.E.V.R. DIRECT FUNCTIONS> in MAIN
MENU, and next selection appears.
2. Select <1.COMMAND INPUT FUNCTION>, and
COMMAND INPUT FUNCTION menu is available
as shown above.
3. Input COMMAND, DATA and ADDRESS
according to adjustment procedure.
4. After adjustment, press [ESC] key to quit.
Note:
1. After operating EVR, turn the VTR off and
on.
2. When the SYSCON PROM is updated,
execute the CAMERA RESET No.1 in
COMMAND INPUT FUNCTION menu.
Press the [F1] and [A] keys together, and
then press [ENTER] key.
3. The difference between CAMERA
RESET No.1 and No.2;
No.1 : Adjustment data isn't reset.
SETUP menu is reset.
No.2 : Adjustment data is also reset.
: [00]
: 00
: 00
]]
[F1],[A]
[F1],[B]
[F1],[C]
[F2],[0]
[↓] : Move To Down
[Enter] : RAM Write

Start Adjustment

1. Select <10.START ADJUSTMENT> in MAIN
MENU.
2. After selecting NTSC/PAL, press ENTER or ESC
key to continue.
3. Adjustment items appear with command, data and
address;
CMD DATA ADR
[02] [00] [04]
CMD : Command.
DATA : Initial data. It is not factory data. It is not VTR
data.
ADR : Address. Confirm the Service Manual that
selected item is correct.
AREA : Adjustable range.
4. Select an adjustment item.
5. Following values are displayed;
Command = [02]
Data = [00]
Address = [04]
Read Data = [06]
Data :
Read Data :
6. To adjust VTR;
1.Input data and press [ENTER] key.
2.Press [+] or [-] key.
7. After adjustment, press [ENTER] key to quit.
Note:
1. After operating EVR, turn the VTR off and
on.
2. START ADJUSTMENT menu is possible
to read out data from VTR.
AREA
[00][FF]
data to be sent to VTR.
data sent from VTR.