Supply Reel Rotor Unit And Take Up Reel Rotor Unit Replacement - Panasonic AJ-D400P Service Manual

10-3. Supply Reel Rotor Unit and Take
Up Reel Rotor Unit Replacement
<<Supply Reel Rotor Unit>>
(Removal)
1. Remove Cassette Cover and Left Side Panel.
2. Remove the Cassette Up Unit.
3. Remove the connector P614 on the Servo
P.C.board.
4. Remove the S5 Post (Refer to item 10-14).
5. Pull up the Arm Return Spring on the Connection
Arm Angle Side.
6. Remove the Connection Arm Angle.
7. Remove the Cut Washer (A) and (B) to remove
the Idler Arm Unit as shown in Figure 10-3-2.
8. Unscrew the 4 screws (C) to remove the Supply
Reel Rotor Unit as shown in Figure 10-3-2.
9. Unscrew the 2 screws (D) to remove the S-Side
M Stopper from Supply Reel Rotor Unit as shown
in Figure 10-3-3.
P606
Fig. 10-3-1 Connection of Servo P.C.Board
CAUTION: Don't touch
magnetized screw driver , when unscrewing the screw
(D).
(Installation)
1. Install the new Supply Reel Rotor Unit according
to the opposite procedures to removing.
2. Confirm the Main Brake Torque (Refer to item 1-3
of Section 3).
3. Adjust the Reel Torque Offset (Refer to item 6-1 of
Section 4).
4. Confirm the tape tension on playback mode.
(Refer to item 1-11 of Section 3).
P607
FG portion with the