Thrust Adjustment Screw Replacement - Panasonic AJ-D400P Service Manual

10-18. Thrust
Replacement
1. Remove the Thrust Adjustment Screw.
2. Enforce cleaning of point department of capstan
shaft with an applicator.
3. Pull the oil (VFK0906) on a new Thrust
Adjustment Screw, and install the upper end of the
Capstan Housing.
4. Turn the Thrust Adjustment Screw slowly to
clockwise until the Capstan Rotor just starts
turning(separate from the Capstan Rotor).
5. Turn the Thrust Adjustment Screw another an
angle of 270 degree from 180 degree (about 225
degree) clockwise as shown in figure 10-18-1.
6. Put the glue (EX: Three Bond 1401B) on the
Thrust Adjustment Screw.
7. Confirm whether the Oil Seal does not come in
contact with the Capstan Housing.
Thrust Adjustment Screw
Oil Seal
Fig. 10-18-1 Location of Oil Seal and Thrust Screw.
Adjustment Screw
Capstan Housing
Thrust Adjustment Screw
Oil
270°
225°
Fig. 10-18-2 Adjustment of Thrust Screw.
0°
180°