A/C Head Tilt Confirmation - Panasonic AJ-D400P Service Manual

Dvcpro series camera recorder

Hide thumbs Also See for AJ-D400P:

Table of Contents

1-19. A/C Head Tilt Confirmation

A/Amax ≥ 0.8

TP505:CUE AUDIO (LCD Board)

ADJUSTMENT SCREW A and G (A/C Head)

VFM3580KM, VFM3680KM

Oscilloscope

VFK1178, VFK1148 (Hex Driver)

1. Playback the CUE portion (6kHz) of the

Alignment tape.

2. Confirm that the screw G and H are not

3. Push the tension arm follow the arrow (B)

direction as shown in figure as range of T2

post does not move. And confirm that the

CUE output level is within specification.

4. If out of specification, loosen the screw G and

adjust the screw A, then tighten the screw G

with 1.0kg torque.

5. The final touch of the adjustment must be

turned clockwise. After this adjustment,

confirm that the screw A is not loosened.

6. If adjust the screw A, Confirm that the tape

pass condition follow Post Limit Confirmation

procedure (item 1-14).

Table of Contents