Removal Of Mechanical Chassis Unit - Panasonic AJ-D400P Service Manual

7-
4. Removal of Mechanical Chassis
Unit
After removing the right side panel according to item 7-3.,
disconnect the connectors (A) and (B) on the RF
P.C.Board. Remove the 3 screws (A) and the screw (B)
and lay down the boards.
Connector (A)
Disconnect the connectors (C), (D),(E) and (F).
Connector (C)
Screws (A)
Screws (B)
Connector (B)
Connector (F)
Connector (D)
Connector (E)
After removing the left side panel according to item 7-2.,
remove the 2 screws (C) for pull out BNC terminal and
disconnect the connector (G) and (H) on the Rear Jack
P.C.Board. Disconnect the connector (I) on the Mother
P.C.Board. and loosen the 2 screws (D) and remove the
2 screws (E).
Remove the mechanical chassis with care not to scratch
the any connectors and cables.
Screws (D)
Connector (G)
Connector (H)
Screws (E)
Screws (C)
Note : When the mechanical chassis unit installed,
confirm the connector P1001 on the Rear Jack
P.C.Board connected correctly.
Connector (I)