Lista Connection And Boot Up - Panasonic AJ-D400P Service Manual

Dvcpro series camera recorder

Hide thumbs Also See for AJ-D400P:

Table of Contents

1-31. LISTA Connection and Boot Up

TP601:ATF ERR (SERVO Board)

TP113:R/P HSW (SERVO Board)

TG300:GND (SERVO Board)

P/C (AD Board should be installed), Oscilloscope

VFM3581KM, VFM3681KM

VFK1481 (LISTA Software), VFK1186 (LISTA Cable)

Connect the LISTA Cable to A/D board on PC.

Connect the Clips of LISTA Cable to test point on Servo Board as follow as below.

".ATF: TP601

#.HSW: TP113

$.GND: TG300

Boot up the LISTA software on DOS mode.

% Install and Boot up.

All files on the floppy disk (VFK1481) copy to created directly on PC (i.e. C:¥LISTA).

Type "LISTA" and press ENTER Key, then boot up the LISTA software.

4. Select the item "DVC PRO" then "AJ-D700" for selected model on the menu. (AJ-D400P/E/D700P/E is

equivalent to AJ-D700).

5. After selected model, appeared alignment tape data on the screen for select the Serial number on the

alignment tape. But if LISTA software have not resisted data of alignment tape, press the ESC key, then

main menu is display on the screen. And select item "<4> Alignment Tape" for entry the data on the

attachment sheet, which is enclosed of alignment tape.

Table of Contents