Installing The Fork Protector; Removing The Lower Triple Clamp - Husqvarna TC 85 2017 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.8

Installing the fork protector

11.9

Removing the lower triple clamp

–
Position the fork protector on the right fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the fork protector on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line and clamp. Mount and tighten screws
E00257-10
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the start number plate. (
–
Remove the front fender. (
–
Remove the handlebar cushion.
Main work
–
Pull fuel tank breather
–
Remove nut
dlebar in an upward direction, and hang it to the side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
E00206-10
–
Remove protective ring
–
Take off the lower triple clamp with the steering stem in a downward direction.
–
Remove the upper steering head bearing.
E00207-10
( p. 65)
( p. 33)
p. 39)
p. 39)

out of the steering stem.
 
. Remove screw , pull off the upper triple clamp with the han-

.
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)

.
p. 32)
35

.

.