Husqvarna TC 85 2017 Owner's Manual page 60

12 BRAKE SYSTEM
Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
Warning
Danger of accidents Brake linings which have not been approved alter the braking efficiency.
Not all brake linings are tested and approved for Husqvarna motorcycles. The structure and friction coefficient of the brake
linings, and thus their brake power, may vary greatly from that of original brake linings.
If brake linings are used that differ from the original equipment, compliance with the original homologation is not guaran-
teed. In this case, the vehicle no longer corresponds to its condition at delivery and the warranty shall be void.
–
Only use brake linings approved and recommended by Husqvarna motorcycles.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable
regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint.
Only use clean brake fluid from a sealed container.
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
E00237-11
–
Remove cotter pin
–
Loosen pin
–
Remove screws
–
Press back the brake linings with a light lateral tilting of the brake caliper on the
brake disc. Carefully pull the brake caliper backward from the brake disc.
–
Press the brake piston back into the basic position and ensure that brake fluid
does not flow out of the brake fluid reservoir, sucking it away if necessary.
E00238-12
–
Remove pin
–
Take off retaining spring
–
Clean the brake caliper.
–
Position the new brake linings.
Info
Always change the brake linings in pairs.
–
Position retaining spring
E00239-10
–
Mount pin
Info
To make it easier to mount the pin, push the retainer spring down.
Make sure the retaining spring is seated correctly.

.
 
with membrane

.

.

and spacers.
 .

and remove the brake linings.

.

but do not tighten yet.
.
58