Preparing For Rides On Dry Sand - Husqvarna TC 85 2017 Owner's Manual

7 PREPARING FOR USE
–
Rides on wet and muddy surfaces. (
–
Rides at high temperature and slow speed. (
–
Rides at low temperature or in snow. (
7.4

Preparing for rides on dry sand

p. 18)
p. 19)
p. 19)
–
Check the radiator cap.
Value on the radiator cap
» If the indicated value does not correspond to the required value:
L00021-10
–
Change the radiator cap.
–
Fit a dust cover on the air filter.
Dust protection device for air filter (77206920100)
Info
See the Husqvarna Motorcycles accessories fitting instructions.
K00201-01
–
Fit a sand cover on the air filter.
Sand protection device for air filter (59006922000)
Info
See the Husqvarna Motorcycles accessories fitting instructions.
–
Adjust the carburetor jetting and setting.
Info
M01072-01
The recommended carburetor tuning is available from your authorized
Husqvarna Motorcycles workshop.
–
Clean the chain.
–
Fit the steel sprocket.
Tip
Do not grease the chain.
–
Clean the radiator fins.
–
Straighten bent radiator fins carefully.
Condition
600868-01
Regular use in sand
–
Change the piston every 10 operating hours.
Warning
Danger of scalding During motorcycle operation, the coolant
gets very hot and is under pressure.
–
Do not open the radiator, the radiator hoses or other cooling
system components if the engine or the cooling system are at
operating temperature.
–
Allow the cooling system and the engine to cool down before
you open the radiator, the radiator hoses or other components
of the cooling system.
–
In the event of scalding, rinse the area affected immediately
with lukewarm water.
1.8 bar (26 psi)
17