Handlebar Position; Adjusting The Handlebar Position - Husqvarna TC 85 2017 Owner's Manual

10 TUNING THE CHASSIS
10.14

Handlebar position

10.15

Adjusting the handlebar position

Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
–
Change the handlebar if the handlebar is damaged or bent.
Guideline
Rebound damping
Comfort
Standard
Sport
Info
Turn clockwise to increase damping; turn counterclockwise to reduce
damping.
On the upper triple clamp, there are two holes at a distance of
Hole distance A
The holes on the handlebar support are placed at a distance of
Hole distance B
The handlebar can be mounted in four different positions. In this way, the handlebar
can be mounted in the position that is most comfortable for the rider.
C00248-10
–
Remove screws
lay it to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
–
Place the handlebar support in the required position. Mount and tighten

screws
C00249-10
Guideline
Screw, handlebar support
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamps. Mount screws
Guideline
Screw, handlebar clamp
Info
Make sure the gap widths are even.
15 mm (0.59 in)
3.5 mm (0.138 in)

. Take off the handlebar clamps. Remove the handlebar and

. Remove the handlebar support.
.
M10
18 clicks
15 clicks
12 clicks

to each other.

from the center.
40 Nm Loctite
(29.5 lbf ft)

and tighten evenly.
M8 20 Nm (14.8 lbf ft)
31
® 243™