Error And Maintenance Messages - Brother MFC-L8610CDW User Manual

Home > Troubleshooting

Error and Maintenance Messages

(MFC-L8900CDW)
If the LCD displays errors and your Android
NFC symbol on your Brother machine to access the Brother Solutions Center and browse the latest FAQs
from your device. (Your mobile telephone provider's message and data rates may apply.)
Make sure the NFC settings of both your Brother machine and your Android
As with any sophisticated office product, errors may occur and supply items may have to be replaced. If this
happens, your machine identifies the error or required routine maintenance and shows the appropriate message.
The most common error and maintenance messages are shown in the table.
Follow the instructions in the Action column to solve the error and remove the message.
You can correct most errors and perform routine maintenance by yourself. If you need more tips: Visit
support.brother.com, and click the FAQs & Troubleshooting page.
Error Message
2-sided Disabled
2-sided Disabled
Reload paper, then
press [Retry].
Access Denied
Calibration
Cartridge Error
Comm.Error
Condensation
> Error and Maintenance Messages
™
Cause
The back cover of the machine
is not closed completely.
Although the size of paper in
the paper tray matches the
paper size that was selected
from the control panel or printer
driver, the machine has stopped
printing when it encountered an
additional, different size of
paper in the tray.
The paper tray was pulled out
before the machine completed
printing on both sides of the
paper.
The function you want to use is
restricted by Secure Function
Lock 3.0.
Calibration failed.
The toner cartridge is not
installed correctly.
Poor telephone line quality
caused a communication error.
Condensation may have formed
inside the machine after a room
temperature change.
device supports the NFC feature, touch your device to the
Action
Close the back cover of the machine until it locks
in the closed position.
Make sure the paper tray contains only the size of
paper you select in either the control panel or
printer driver, then press Start.
Reinstall the paper tray and press Start.
Call your administrator to check your Secure
Function Lock Settings.
• Press and hold down
machine. Wait a few seconds, and then turn it
on again. Perform the color calibration again
using the LCD.
• Install a new belt unit.
• If the problem continues, contact Brother
Customer Service or your local Brother dealer.
Pull out the drum unit, remove the toner cartridge
for the color that is indicated on the LCD, and
place it back in the drum unit. Install the drum unit
in the machine again.
If the problem continues, contact Brother
Customer Service or your local Brother dealer.
Send the fax again or connect the machine to
another telephone line. If the problem continues,
contact the telephone company and ask them to
check your telephone line.
Leave the machine turned on. Wait for 30 minutes
with the front cover in the open position. Then
turn off the machine and close the cover. Turn it
on again.
™
device are set to On.
to turn off the
558