Brother MFC-L8610CDW User Manual page 567

Error Message
Jam Inside
Jam MP Tray
Jam Rear
Jam Tray 1
Jam Tray 2
Jam Tray 3
Jam Tray 4
Limit Exceeded
Media Type Mismatch
No Belt Unit
No HUB Support
No Drum Unit
No Paper
No Paper Fed T1
No Paper Fed T2
No Paper Fed T3
No Paper Fed T4
No Paper MP
No Paper T1
No Paper T2
No Paper T3
No Paper T4
No Toner
Cause
The paper is jammed inside the
machine.
The paper is jammed in the MP
tray.
The paper is jammed in the
back of the machine.
The paper is jammed in the
indicated paper tray.
The print limit set in Secure
Function Lock 3.0 was reached.
The media type specified in the
printer driver differs from the
paper type specified in the
machine's menu.
The belt unit is not installed or
not installed correctly.
A USB hub device is connected
to the USB direct interface.
The drum unit is not installed
correctly.
The machine is out of paper, or
paper is not loaded correctly in
the paper tray.
The machine failed to feed
paper from the indicated paper
tray.
The MP tray is out of paper, or
paper is not loaded correctly in
the MP tray.
The machine failed to feed
paper from the indicated paper
tray.
The toner cartridge for the color
indicated on the LCD is not
installed or not installed
correctly.
Action
Open the front cover, remove the toner cartridge
and drum unit assembly, and pull out all jammed
paper. Close the front cover.
Remove all jammed paper from in and around the
MP tray. Press Retry.
Open the fuser cover and remove all jammed
paper. Close the fuser cover. If the error message
remains, press Retry
Pull out the paper tray and remove all jammed
paper as shown in the animation on the LCD.
Call your administrator to check your Secure
Function Lock Settings.
Load the correct type of paper in the tray
indicated on the LCD, and then select the correct
media type in the Paper Type setting on the
machine.
Reinstall the belt unit.
Disconnect the USB hub device from the USB
direct interface.
Reinstall the toner cartridge and drum unit
assembly.
• Refill paper in the paper tray. Make sure the
paper guides are set to the correct size.
• If paper is in the tray, remove it and load it
again. Make sure the paper guides are set to
the correct size.
• Do not overfill the paper tray.
Pull out the paper tray indicated on the LCD and
remove all jammed paper.
Do one of the following:
• Refill paper in the MP tray. Make sure the
paper guides are set to the correct size.
• If paper is in the tray, remove it and load it
again. Make sure the paper guides are set to
the correct size.
Do one of the following:
• Refill paper in the paper tray indicated on the
LCD. Make sure the paper guides are set to
the correct size.
• If paper is in the tray, remove it and load it
again. Make sure the paper guides are set to
the correct size.
Do not overfill the paper tray.
Remove the toner cartridge for the color indicated
on the LCD from the drum unit, and put the toner
cartridge back into the drum unit. If the problem
continues, replace the toner cartridge.
560