DSC 3G2055 Installation Manual page 25

[027] Ethernet 2 Transmission
Default (00)
Program 00 to disable this event transmission or FF to enable. See System Test
Options (above) for details on settings.
[028] Cellular 1 Transmission
Default (FF)
Program 00 to disable this event transmission or FF to enable. See System Test
Options (above) for details on settings.
[029] Cellular 2 Transmission
Default (00)
Program 00 to disable this event transmission or FF to enable. See System Test
Options (above) for details on settings.
NOTE: The time interval (in minutes) between periodic tests is programmed in
Section [125] (Ethernet) and Section [225] (Cellular).
[030] FTC Restore
Default (FF)
Program 00 to disable this event transmission or FF to enable. This event will occur
when an FTC Trouble on the system restores.
[031] Priority Tamper Alarm
Program 00 to disable this event or FF to enable. This event will occur when panel
tampered during the entry delay.
[032] Priority Tamper Restore
Program 00 to disable this event or FF to enable.This event will occur when panel
tamper restored.
Table 10: Priority Tamper/Tamper Restore
Event
Identifier
Priority
BA
Tamper
Priority
BR
Tamper
Restore
[033] Communicator Firmware Update Begin
Default (FF);
Program 00 to disable this event transmission or FF to enable. This event will occur
when the communicator firmware update begins.
[034] Communicator Firmware Update Successful
Default (FF);
Program 00 to disable this event transmission or FF to enable. This event will occur
when the communicator firmware update successfully completed.
[035] Panel Firmware Update Begin
Default (FF);
Program 00 to disable this event transmission or FF to enable. This event will occur
when the panel firmware update begins.
SIA
SIA
Reporting
Code
000
000
Contact
Contact ID
ID Event
Qualifier
Code
1 1
3 1
25
Contact
Contact
ID
ID User/
Reporting
Zone
Code
37 000
37 000