Table of Contents
Advertisement
The SMS Message format is in 3 parts: Command, Partition Label (or only the parti-
tion number), and Access Code.
• If an Access Code is included in the message, it is sent to the control panel for
validation, along with the requested function.
• If the panel is configured to require an Access Code and the code is not sent (or
invalid) the panel will fail the function (unsuccessful).
• If the panel fails the function, an SMS response message is sent to the user. The
SMS response will echo the command sent, followed by the label "unsuccessful" .
(e.g., "night arm partition 2 1234 unsuccessful").
• The partition label or partition number may be excluded from the SMS request in a
single partition system (e.g., disarm 9123).
NOTE: The communicator cellular phone number can be viewed in Section [851],
[996] and/or [851], [229] or by user entering [*][6], then scrolling down to 'SMS
Programming" and scrolling down to "Cellular phone No. " [<] [>] "Cellular Phone
No. " at the keypad. An Access Code is required for all SMS commands, except Help.
[601] Stay Arm
Default (Stay Arm);
Send this command to the system to stay arm. It may be followed by a Partition Label
or partition number and Access Code.
[602] Away Arm
Default (Away Arm);
Send this command to the system to away arm. It may be followed by a Partition
Label or partition number and Access Code.
[603] Night Arm
Default (Night Arm);
Send this command to the system to night arm. It may be followed by a Partition
Label or partition number and Access Code.
[604] Disarm
Default (Disarm);
Send this command to the system to disarm. It may be followed by a Partition Label
or partition number and Access Code.
[605] - [608] Activate Command Output 1 - 4
Default (Activate Command Output n);
Where n is a number from 1 - 4. Send this command to the system to activate a com-
mand output. It may be followed by a Partition Label or partition number and Access
Code.
[609] - [612] Deactivate Command Output 1 - 4
Default (Deactivate Command Output n);
Where n is a number from 1 - 4. Send this command to the system to deactivate a
command output. This command may be followed by a Partition Label or partition
number and optional Access Code.
[613] Bypass
Default (Bypass);
Send this command to the system to bypass a Zone. This command should be fol-
lowed by a Zone label or Zone number and Access Code.
[614] Unbypass
Default (Unbypass);
Send this command to the system to unbypass a Zone. This command should be fol-
lowed by the Zone label or Zone number and Access Code.
33
Advertisement
Table of Contents
