New Lap Recording; Data Retrieval Mode - Triumph Speed Triple S Owner's Handbook Manual

General Information

New Lap Recording

1
ix 3
1. SCROLL button
At the end of the lap, pressing the
SCROLL button again will register the
start of a new lap. The display will show
the last lap time for five seconds, then
the new lap number for five seconds.
After this time, the speedometer display
will show the current lap number and
the display screen will show the current
lap time.
48

Data Retrieval Mode

The data retrieval mode can be accessed
in one of two ways:
• With the ignition in the ON position,
from the lap timer display, press
button 'B'.
• From the Data Recording Mode, with
the engine running
motorcycle stationary, press the
SCROLL button for two seconds. This
will return the display to the LAP
display. Then press button 'B'.
Note:
• The data retrieval mode cannot be
accessed whilst the motorcycle is in
motion.
When the data retrieval
accessed, the lap time for the first lap
will be displayed. The lap number will be
displayed in the speedometer display
position.
Press and release button 'A' until the
desired lap (up to a maximum of 50 laps)
is displayed.
Press and release button 'B' to scroll
through the lap data.
Lap Timer Reset and Exit
To reset the lap timer and exit lap timer,
press button 'B' for two seconds. After
two seconds, the lap timer will reset and
LAP will be shown in the display screen.
This will delete the stored data for all
stored laps.
To exit the data retrieval mode without
resetting the lap timer, press button 'A'
for two second, LAP will be shown in the
display screen. Press
button 'A' to the desired display.
and the
mode is
and release