Right Handlebar Switches; Stop Position; Run Position; Start Position - Triumph Speed Triple S Owner's Handbook Manual

General Information

Right Handlebar Switches

2
3
1
4
5
cite_1
1. Engine start/stop switch

2. STOP position

3. RUN position

4. START position

5. Hazard warning light switch
STOP Position
The STOP position is for emergency use.
If an emergency arises which requires
the engine to be stopped, move the
engine start/stop switch to the STOP
position.
Note:
• Although the engine stop position
stops the engine, it does not turn off
all the electrical circuits and may
cause difficulty in restarting the
engine due to a discharged battery.
Ordinarily, only the ignition switch
should be used to stop the engine.
Caution
Do not leave the ignition switch in the
ON position unless the engine is
running as this may cause damage to
electrical components
discharge the battery.
56
RUN Position
In addition to the ignition switch being
turned to the ON position, the engine
start/stop switch must be in the RUN
position for the motorcycle to operate.
START Position
The START position operates the electric
starter. For the starter to operate, the
clutch lever must be pulled to the
handlebar and the engine start/stop
switch in the START position.
Note:
• Even if the clutch lever is pulled to
the handlebar, the starter will not
operate if the side stand is down and
a gear is engaged.

Hazard Warning Lights

To turn the hazard warning lights on or
off, press and release the hazard
warning light switch.
The ignition must be switched ON for the
hazard warning lights to function.
and will