• After opening the top cover, use the prop to keep the cover raised so that it does not close unexpectedly.
• Make sure that the top cover is closed, then turn on the power switch on the back of the machine. Before
closing the cover, turning on the power may cause the machine to operate and cause injury.
Otherwise, your hand caught may be caught between the cover and the machine.
If not complete, repeat the fill procedure using the short time interval until all of the ink channels have
reached the Print Heads and you see no gaps in the ink tubes.
If not complete, repeat the fill procedure using the short time interval until all of the ink channels have
reached the Print Heads and you see no gaps in the ink tubes.
7: Performing a Nozzle Check
Now that the lines have been filled with ink you will need to perform a Nozzle
Check. First we need to set the table height by pressing the menu <
selecting Maintenance; then select the Motion tab and select Auto Adjust Height.
This will lower the table, move it into the printer and raise it until it triggers the
Figure 2.6-8: Ink Line Filling Point
41
≡
> button and