Skycoded Display Panel; Battery Charger; Ac Outlet On Platform; Pothole Protection Device - Skyjack SJIII 3219 Operating Manual

Component Identification

3.5 Component Identification
The following descriptions are for identification,
explanation and locating purposes only.

3.5-1 SkyCoded Display Panel

This panel is located in the hydraulic/electric tray. It
contains the following controls:
2
Figure 3-1. SkyCoded Display Panel
1. Circuit Breaker Resets - In the event of power
overload or positive circuit grounding, the circuit
breaker pops out. Push the breaker back in to
reset.
2. SkyCoded Display - This display screen shows
operating information and parameters such as
operating hours, tilt angle, and fault codes.

3.5-2 Battery Charger

The charger is located at the rear of the base or inside
the battery tray. Refer to
charging operation.
Figure 3-2. Battery Charger
Page 38
1
Section 3.13-2 for battery

3.5-3 AC Outlet on Platform

This outlet is a source of AC power on the platform.
Figure 3-3. AC Outlet on Platform

3.5-4 Pothole Protection Device

Figure 3-4. Pothole Protection Device
1. Pothole Protection Device - This device
consists of a set of mechanically actuated steel
weldments located under the hydraulic/electric
tray and battery tray. These weldments will
automatically rotate for reduced ground clearance
when elevating the aerial platform. If the pothole
protection device has not fully lowered, the drive
function will be disabled.
Section 3 - Operation
1
SJIII DC Electric