Operating Controls Identification
The following descriptions are for identification,
explanation and locating purposes only. A qualified
operator MUST read and completely understand these
descriptions before operating this work platform.
Procedures for operating this work platform are
detailed in the
"Operating
standard and optional controls are identified in this
section. Therefore, some controls may be included
that are not furnished on your work platform.
Base Controls
Electrical Panel
1
2
3
Figure 2-1. Electrical Panel(3220/3226)
Electrical Panel
This control station is located in the Hydraulic/Electric
Tray. It contains the following controls:
1-
Buzzer Alarm - This audible pulse alarm sounds
when platform is being electrically lowered. On
machines with certain options, this alarm will
sound when any control function is selected.
2- Up/Down Toggle Switch (ANSI and CSA) This
toggle type switch raises or lowers the platform
to desired a height.(3220/3226 ONLY)
3-
Hourmeter - Activated when the pump/motor
runs, this gauge records work platform operating
time.
4-
15 Amp Circuit Breaker Resets - In the event
of a power overload or positive circuit grounding,
circuit breaker will pop out. Make the necessary
corrections, then depress the push-button to
reset.
SJIII Series - The COMPACTS &
CONVENTIONALS
122908AD
SECTION 2
OPERATION
Procedures"
section. Both
4
Dec. 2002
Emergency Battery Disconnect Switch
Figure 2-2. Emergency Battery Disconnect Switch
1-
Emergency Battery Disconnect Switch -
Located on the rear of the base, this switch,
when in "OFF" position, disconnects power to
all control and power circuits. Switch MUST be
in "ON" position to operate any electric control
circuit.
Base Control
Box
3220/3226(CE)
2
Figure 2-3a. Base Control Box (CE)
Base Control Box (CE)
This metal control station is mounted on the rear of
the base. It contains the following controls:
1-
Platform Up/Down Toggle Switch - This toggle
type switch raises or lowers the platform to a
desired height.
2-
Emergency Stop Button - This red "mushroom-
head" shaped button switch is designed to
disengage power to the platform controls.
1
2
1
SECTION 2, Page 13