Component Identification; Main Power Disconnect Switch; Tilt Alarm; Base Control Console - Skyjack SJIII 3219 Operating Manual

Control Functions

2.2 Component Identification

The following descriptions are for identification,
explanation and locating purposes only.

2.2-1 Main Power Disconnect Switch

This switch is located at the rear of the base.
Figure 2-1. Main Power Disconnect Switch
1. Main Power Disconnect Switch - This switch,
when in " " off position, disconnects power to
all circuits. Switch must be in " " on position to
operate any circuit. Turn switch "
transporting aerial platform.

2.2-2 Tilt Alarm

The aerial platform is equipped with a device which
senses when the aerial platform is out of level in any
direction. When activated, it disables drive and lift
functions of the aerial platform and an alarm produces
an audible sound accompanied by the amber light (if
equipped).
WARNING
If the tilt alarm sounds and the platform
does not, or only partially raises,
immediately lower the platform completely
and ensure that the aerial platform is on
a firm level surface.
Page 14
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings

2.2-3 Base Control Console

This control console is located at the rear of the base.
It contains the following controls:
1
" off when
1.
2.
3.
contained in this operating manual and on the aerial platform.
Section 2 - Familiarization
1
2
3
Figure 2-2. Base Control Console
Lower/Neutral/Raise Switch - This switch controls
" " raising or " " lowering of platform.
Off/Platform/Base Key Switch - This three-way
switch allows the operator to turn "
to aerial platform or to activate either "
or " " base controls.
Emergency Stop Button - This button "
when depressed, disconnects power to the control
circuit.
" off power
" platform
",
SJIII DC Electric