Visual & Daily Maintenance Inspections; Labels; Limit Switches; Hydraulic - Skyjack SJIII 3219 Operating Manual

Visual & Maintenance Inspection
CONVENTIONALS
2.3 Visual & Daily Maintenance Inspections
Begin the visual and daily maintenance inspections
by checking each item in sequence for the conditions
listed in this section.
WARNING
To avoid injury, do not operate an aerial
platform until all malfunctions have been
corrected.
WARNING
To avoid possible injury, ensure aerial
platform power is off during your visual
and daily maintenance inspections.
CAUTION
Ensure aerial platform is on a firm, level
surface.
NOTE
While performing
inspections in different areas, be aware to
also inspect limit switches, electrical and
hydraulic components.

2.3-1 Labels

Refer to Section 5 - Labels in this manual and determine
that all labels are in place and are legible.
Page 18
It is the responsibility of the operator to read, completely understand and follow all instructions and warnings
visual and daily
contained in this operating manual and on the aerial platform.
Pothole Protection
Limit Switch
COMPACTS
2.3-2 Electrical
Maintaining the electrical components is essential to
good performance and service life of the aerial platform.
Inspect the following areas for chafed, corroded and
loose wires:
• base to platform cables and wiring harness
• battery tray wiring harnesses
• hydraulic/electrical wiring harnesses

2.3-3 Limit Switches

Ensure limit switches are properly secured with no signs
of visible damage and movement is not obstructed.

2.3-4 Hydraulic

Maintaining the hydraulic components is essential to
good performance and service life of the aerial platform.
Perform a visual inspection around the following
areas:
• hoses and fittings
• all hydraulic cylinders
• all hydraulic manifolds
• the underside of the base
• ground area under the aerial platform
Section 2 - Familiarization
SJIII DC Electric