Using Optional Control Box With Long Cable From Ground - Skyjack SJIII 3219 Operating Manual

Component Identification
3.6-4 Using Optional Control Box with Long
Cable from Ground:
WARNING
Skyjack scissor lifts are to be operated
from the operator's position on the
platform with the control box secured on
the mounting bracket at the front right
portion of the platform. Operation of the
unit from the ground is permissible only
when maintaining the lift or, in limited
circumstances, when an obstruction
precludes the safe operation of the
lift from the operator's position on the
platform. Operation from the ground
is to be performed as set forth in the
Operating Manual.
1. Before operating this aerial platform, perform the
following steps:
• Visual and daily maintenance inspections
(see Section 2.3)
• Function tests (see
2. Ensure the platform is in the fully-stowed (lowered)
position.
To protect against unintended movement
of the aerial platform, push in the
emergency stop button after you have
arrived at your desired location.
3. Disconnect and remove platform control console
from the mounting bracket at the front right portion
of the platform.
Ensure that you maintain three points of
contact when using the ladder to mount/
dismount platform.
Page 42
Section 2.4).
WARNING
WARNING
Operation from the Ground:
4. The control box with long cable may be connected
to the lower base control connector or to the
platform control connector.
NOTE
For some models, the connection is located
beneath an access panel which requires
that the scissor assembly be raised to
access it.
Figure 3-10. Control Box with Long Cable
Section 3 - Operation
SJIII DC Electric