Flow Programming - DENTSPLY Clamus DUAL Manual

FLOW Programming

Temperature Settings:
• Press the
use the
• The LED light next to the
Flow handpiece is heating up. Once the device has reached set
temperature, the LED light next to the
Flow Rate Settings:
• Press the
flow rate.
• The LED light to the left of the
the flow rate has been enabled.
ª Press either
10% increments.
ª Holding down one arrow button will result in rapid scrolling through
the flow range (20 minimum to 100 maximum).
ª Flow rate is displayed on the numerical LED window.
Factory Default Settings:
The two Preset buttons
sides of the device.
• Pack: 200°C temperature and 40% tone volume.
• Flow: 160°C temperature and 60% flow rate.
• Thermal Response button
Custom Preset Settings:
The Preset buttons
personal settings.
• Press and hold either preset button for at least two seconds.
• The preset button's LED will illuminate indicating that it is active.
• Settings for both the Pack side and Flow side are now stored in
memory.
button on the right (Flow) side of the keypad and then
buttons to set the desired temperature.
button will flash, indicating that the
button and use the
repeatedly to increase/decrease the flow rate in
store the settings for both the Pack and Flow
is set at 90°C and is fixed.
can be manually programmed to store your
button will light steadily.
buttons to set the desired
button will illuminate indicating
13