Directions For Use; Setting Up The Dual - DENTSPLY Clamus DUAL Manual

Directions For Use

Setting Up The Dual

Figure 2
Component & Console
Identification
360° Activation Cuff
Pack Activation Indicator
Blue LED Indicates Pack
Numerical LED Display
Thermal Response Tip
Pack Handpiece
Connector
1. Unpack the console and check that the Voltage Selector is set to the
proper voltage. See Fig. 3.
•
•
•
Figure 3
Back of Device
2. Remove packaging from handpieces.
8
Side In Use
Pack Temperature
Pack Tone Volume
Preset Buttons
Use the 115V position for 110-120V 60Hz voltages, and the 230V
position for 220-250V 50Hz voltages. Always unplug the unit
before changing fuses or adjusting the voltage selector.
To change voltage, use a flat head screwdriver to turn the Voltage
Selector on the back of the console to the proper voltage setting.
To change fuse, replace the fuse to match voltage (see
Specifications). Replace with 0.6 A, 250 V Slo-Blo
230 V). For replacement, press on the black plastic clip of the fuse
compartment, pull out and replace with the correct fuse.
Programming Port
(For Manufacturing
Use Only)
Flow Handpiece
Pack Handpiece
Up/Down Arrow
Buttons
Voltage
Selector
Handpiece Cartridge Nut
Gutta-Percha Level
Indicator
360° Activation Cuff
Blue LED Indicates Flow
Side In Use
Flow Temperature
Flow Rate
Flow Return
On/Off Power Switch
Flow Handpiece Connector
®
fuse (0.3 A for
AC Power Cord Receptacle
Fuse Compartment