12.11 Initial setup for room
monitors
The first time the room monitor is turned on, it will
automatically attempt to download its configuration file
over the network from the computer being used for PC
programming.
1
Make sure the computer used for PC programming
is connected to the network.
2
Connect the room monitor to a power source.
R The room monitor turns on automatically when it
receives power from the LAN cable or the power
supply unit.
3
If room monitors were identified by their MAC
addresses during PC programming
Wait for the room monitor to download its
configuration file from the computer used for PC
programming.
If room monitors were identified by room number
during PC programming
Enter the room monitor's room number when
prompted. The room monitor will then attempt to
download its configuration file from the computer
used for PC programming.
12. Installation
39