Panasonic VL-MN1000 Installation And Operating Instructions Manual page 33

6
Solder the ends of the DC wires to the DC plug. Use
insulation sleeves to insulate the wires.
DC+
A
DC-
A DC plug
B DC wires
C Insulation sleeve
7
Replace the cable covers and then securely fasten
the cable cover screws.
C
C
DC+
B
DC-
12.6.2 Mounting on a DIN rail
Attach the power supply unit to the DIN rail so that the
bottom hook is positioned at the bottom of the power
supply unit.
1
Hang the top hooks of the power supply unit on the
top of the DIN rail.
R At this point the power supply unit will be hanging
from the DIN rail but will not be secure.
2
Pull the lever down, make sure the bottom of the
power supply unit is flat against the DIN rail, and then
release to lever.
R The bottom hook will slide up, securing the
bottom of the power supply unit to the DIN rail.
A
C B
A Top hooks
B Lever
C Bottom hook
12.6.3 Attaching directly to a wall
Attach the power supply unit to the wall securely using
the 2 mounting screws.
12. Installation
33