Room Name Plates - Panasonic VL-VM701 Installation And Operating Instructions Manual

4. Installation

4.10 Room name plates

The room name plates of the lobby station can be attached in the follow ways.
– Attached so that room name plates can be easily attached and removed in order to change the names of residents.
– Attached so that room name plates cannot be easily attached and removed (tamper prevention). After consulting
with contractors and facility staff, use screws to secure each name button module to the lobby station.
Removing/attaching room name plates
1. Remove the name plate button as shown in (A) and (B) below.
2. Remove the name plate by sliding it (C) out from the button.
3. Remove the name plate as shown in (D) below and change the contents of the name plate.
4. Reattach the name plate button as shown in (E) below.
R Make sure that the name plate button is securely attached.
Attaching the room name plates so that they cannot be easily removed
1. Remove the screws (A) on the left and right side of the button module and panel, and then remove the button
module and panel.
2. As shown in the following illustrations, from the rear of the button module, secure the left and right sides of the
button module with screws (B).
R The number of included screws used differs depending on the button module used. Refer to page 10 for
information.
3. Reattach the button module and panel by securing the screws (C) on the left and right side of the button module
and panel. Make sure the panel is securely attached.
Example: 4-button module
44
A
B
A
C
D
B
E
E
C