HEIDENHAIN TNC 320 User Manual page 9

Changed Functions of Software
340 55x-04
In Cycle 22 you can now define a tool name also for the coarse
roughing tool (see "ROUGH-OUT (Cycle 22, DIN/ISO: G122)" on
page 182).
With Cycle 25 Contour Train, closed contours can now also be
programmed.
The pocket-, stud- and slot-milling cycles 210 to 214 were removed
from the standard soft-key row (CYCL DEF >
POCKETS/STUDS/SLOTS). For reasons of compatibility, the cycles
will still be available, and can be selected via the GOTO key.
The additional status display has been revised. The following
improvements were made (see User's Manual for Conversational
Programming)
A new overview page with the most important status displays
was introduced.
The tolerance values set in Cycle 32 are displayed.
Tool changes are now also possible during mid-program startup.
Language-sensitive texts can now be output with FN16 F-Print.
The soft-key structure of the SPEC FCT function was changed and
adapted to the iTNC 530.
HEIDENHAIN TNC 320 9