HEIDENHAIN TNC 320 User Manual page 435

Cycle programming

Hide thumbs Also See for TNC 320:

Table of Contents

Touch probe cycles

Cycle designation

Reference plane

Calibrate TT

Measure/Inspect the tool length

Measure/Inspect the tool radius

Measure/Inspect the tool length and the tool radius

Basic rotation using two points

Basic rotation over two holes

Basic rotation over two studs

Compensate misalignment with rotary axis

Set basic rotation

Compensate misalignment with the C axis

Reference point at slot center (FCL 3 function)

Reference point at ridge center (FCL 3 function)

Datum from inside of rectangle

Datum from outside of rectangle

Datum from inside of circle (hole)

Datum from outside of circle (stud)

Datum from outside of corner

Datum from inside of corner

Datum from circle center

Datum in touch probe axis

Datum at center between four holes

Datum in any one axis

Workpiece—measure angle

Workpiece—measure hole (center and diameter of hole)

Workpiece—measure circle from outside (diameter of circular stud)

HEIDENHAIN TNC 320

Chapters

Table of Contents