HEIDENHAIN TNC 320 User Manual page 56

Cycle programming

Hide thumbs Also See for TNC 320:

Table of Contents

Selecting a point table in the program

In the Programming and Editing mode of operation, select the

program for which you want to activate the point table:

Press the PGM CALL key to call the function for

selecting the point table.

Press the POINT TABLE soft key.

Enter the name of the point table and confirm your entry with the END

key. If the point table is not stored in the same directory as the NC

program, you must enter the complete path.

Example NC block

7 SEL PATTERN "TNC:\DIRKT5\NUST35.PNT"

Using Fixed Cycles

Chapters

Table of Contents