HEIDENHAIN TNC 320 User Manual page 291

Cycle programming

Hide thumbs Also See for TNC 320:

Table of Contents

Characteristics common to all touch probe

cycles for measuring workpiece misalignment

For Cycles 400, 401 and 402 you can define through parameter Q307

Preset value for rotation angle whether the measurement result

is to be corrected by a known angle α (see figure at right). This enables

you to measure the basic rotation against any straight line

workpiece and to establish the reference to the actual 0° direction 2.

HEIDENHAIN TNC 320

Chapters

Table of Contents