HEIDENHAIN TNC 320 User Manual page 7

New Functions of Software
340 55x-04
The PATTERN DEF function for defining patterns was introduced (see
"Pattern Definition PATTERN DEF" on page 46)
The SEL PATTERN function makes it possible to select point tables
(see "Selecting a point table in the program" on page 56)
With the CYCL CALL PAT function, cycles can now be run in
connection with point tables (see "Calling a cycle in connection with
point tables" on page 57)
The DECLARE CONTOUR function can now also define the depth of the
contour (see "Entering a simple contour formula" on page 225)
New machining cycle for single-lip deep-hole drilling (see "SINGLE-
LIP DEEP-HOLE DRILLING (Cycle 241, DIN/ISO: G241)" on page 86)
The new fixed cycles 251 to 257 were introduced for milling
pockets, studs and slots (see "Overview" on page 128)
Touch Probe Cycle 412: Additional parameter Q365 "Type of
traverse" (see "DATUM FROM INSIDE OF CIRCLE (Cycle 412,
DIN/ISO: G412)" on page 330)
Touch Probe Cycle 413: Additional parameter Q365 "Type of
traverse" (see "DATUM FROM OUTSIDE OF CIRCLE (Cycle 413,
DIN/ISO: G413)" on page 334)
Touch Probe Cycle 416: Additional parameter Q320 (Set-up
clearance, (see "DATUM CIRCLE CENTER (Cycle 416, DIN/ISO:
G416)" on page 347))
Touch Probe Cycle 421: Additional parameter Q365 "Type of
traverse" (see "MEASURE HOLE (Cycle 421, DIN/ISO: G421)" on
page 378)
Touch Probe Cycle 422: Additional parameter Q365 "Type of
traverse" (see "MEAS. CIRCLE OUTSIDE (Cycle 422, DIN/ISO:
G422)" on page 382)
Touch Probe Cycle 425 (MEASURE SLOT) was expanded by
parameters Q301 (Move to clearance height) and Q320 (Set-up
clearance) ((see "MEASURE INSIDE WIDTH (Cycle 425, DIN/ISO:
G425)" on page 394))
Datum tables can now also be selected in the machine operating
modes Program Run, Full Sequence and Program Run, Single Block
(STATUS M).
The definition of feed rates in fixed cycles can now also include FU
and FZ values
HEIDENHAIN TNC 320 7