HEIDENHAIN TNC 320 User Manual page 11
Cycle programming
Hide thumbs
Also See for TNC 320:
- User manual (670 pages) ,
- User's manual for cycle programming (465 pages)
Table of Contents
Advertisement
Changed Functions of Software
340 55x-05
The status display for Q parameters was revised (see User's Manual
for Conversational Programming).
The tool table was expanded by the LAST_USE column (see User's
Manual for Conversational Programming).
The graphic simulation was extended and adapted to the iTNC 530
(see User's Manual for Conversational Programming).
Touch probe cycles can now also be used in the tilted working plane
(see User's Manual for Conversational Programming).
HEIDENHAIN TNC 320
11
Advertisement
Chapters
Table of Contents
