HEIDENHAIN TNC 320 User Manual page 367

Cycle
430 MEASURE BOLT HOLE CIRCLE
(2nd soft-key row) Measuring position
and diameter of a bolt hole circle
431 MEASURE PLANE (2nd soft-key
row) Measuring the A and B axis angles
of a plane
Recording the results of measurement
For all cycles in which you automatically measure workpieces (with
the exception of Cycles 0 and 1), you can have the TNC record the
measurement results. In the respective probing cycle you can define
if the TNC is to
Save the measuring log to a file
Interrupt program run and display the measuring log on the screen
Create no measuring log
If you want to save the measuring log to a file, the TNC, by default,
saves the data as an ASCII file in the directory TNC:\..
Use the HEIDENHAIN data transfer software TNCremo if
you wish to output the measuring log via the data
interface.
HEIDENHAIN TNC 320
Soft key Page
Page 403
Page 407
367