Steam Generation System - AEG BS9314001 User Manual

Hide thumbs Also See for BS9314001:
Table of Contents

Advertisement

The display shows the duration of the
function. An acoustic signal sounds when
the programme is completed.
3. Touch a sensor field to deactivate
the signal.
4. Wipe out the appliance with a soft
cloth. Remove the water from the
steam generator.
Keep the appliance door open for
approximately 1 hour. Wait until the
appliance is dry. To speed up the drying
you can heat up the appliance with hot
air at temperature 150 °C for
approximately 15 minutes.

13.4 Steam generation system

CAUTION!
Dry the steam generator after
each use. Remove the water
with the sponge.
Remove the limescale with
water and vinegar.
CAUTION!
Chemical de-scaling agents
can cause damage to the
enamel. Follow the
instructions of the
manufacturer.
1. To clean the water drawer and the
steam generator, put the water and
vinegar mixture (approximately 250
ml) through the water drawer into the
steam generator. Wait for
approximately 10 minutes.
2. Remove the water and vinegar with
the sponge.
3. Put clean water (100 - 200 ml) into the
water drawer to flush the steam
generation system.
4. Remove the water from the steam
generator with the sponge and rub it
dry.
5. Keep the door open to let the
appliance dry fully.
13.5 Removing and installing
the oven door
You can remove the oven door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
A
3. Close the oven door to the first
opening position (approximately 70°
angle).
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5. Put the door with the outer side
down on a soft cloth on a stable
surface. This is to prevent scratches.
6. Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
2
B
7. Pull the door trim to the front to
remove it.
8. Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
ENGLISH
43
A
1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bs9304001

Table of Contents