Steam Generation System - AEG BS9314001M User Manual

13.4 Steam generation system

CAUTION!
Dry the steam generator
after each use. Remove the
water with the sponge.
Remove the limescale with
water and vinegar.
CAUTION!
Chemical de-scaling agents
can cause damage to the
enamel. Follow the
instructions of the
manufacturer.
1. To clean the water drawer and the
steam generator, put the water and
vinegar mixture (approximately 250
ml) through the water drawer into the
steam generator. Wait for
approximately 10 minutes.
2. Remove the water and vinegar with
the sponge.
3. Put clean water (100 - 200 ml) into the
water drawer to flush the steam
generation system.
4. Remove the water from the steam
generator with the sponge and rub it
dry.
5. Keep the door open to let the
appliance dry fully.
13.5 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
A
3. Close the oven door to the first
opening position (approximately 70°
angle).
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5. Put the door with the outer side
down on a soft cloth on a stable
surface. This is to prevent scratches.
6. Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
2
B
7. Pull the door trim to the front to
remove it.
8. Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger and the door.
ENGLISH 45
A
1