Table of Contents
Advertisement
7. After the end of the first part, empty
the grill- / roasting pan and put it on
the first shelf position again.
8. Press
9. Fill the water drawer with fresh water.
Make sure there is no remaining
cleaning solution inside the water
drawer.
10. Fit the water drawer in the appliance.
11. Press
This activates the second part of the
procedure: Descaling. It will rinse the
steam generation circuit.
Remove the grill- / roasting pan after the
end of the procedure.
If the appliance is humid and wet, wipe it
out with a dry cloth. Let the appliance
dry fully with the door open.
12.8 Descaling reminder
There are two descaling reminders which
remind you to perform the function:
Descaling. These reminders activate
each time you switch off the appliance.
The soft reminder reminds and
recommends you to perform the
descaling cycle.
The hard reminder obligates you to
perform the descaling.
12.9 Steam generation system
- Rinsing
Remove all accessories.
Select the function from the menu:
Cleaning. The user interface will guide
you through the procedure.
EURO Appliances - euappliances.info
.
.
The duration of this part is
around 35 minutes.
If the function: Descaling is
not performed in the correct
way, the display will show a
message to repeat it.
If you do not descale the
appliance when the hard
reminder is on, you cannot
use the steam functions.
You cannot disable the
descaling reminder.
The duration of the function is around 30
minutes.
The light in this function is off.
1. Put the baking tray on the first shelf
position.
2. Press
.
3. Fill the water drawer with fresh water.
4. Press
.
Remove the baking tray after the end of
the procedure.
12.10 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
A
3. Close the oven door to the first
opening position (approximately 70°
angle).
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5. Put the door with the outer side
down on a soft cloth on a stable
surface. This is to prevent scratches.
6. Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
ENGLISH
63
A
Advertisement
Table of Contents
